Mold Remediation & Co.
Guide · 6 min read · Reviewed November 2026

The mold remediation process, step by step

Last reviewed · Based on EPA guidance · Editorial policy

Quick answer

A proper mold remediation job follows seven steps: inspection, containment, HEPA air filtration, removal of contaminated materials, cleaning, drying and moisture repair, and a clearance check.

1. Inspection and moisture mapping

The contractor identifies every affected area and the source of moisture, often with moisture meters and thermal imaging. You should receive a written scope.

2. Containment

The work area is sealed with plastic sheeting. Negative air pressure keeps spores from escaping into the rest of the home.

3. HEPA air filtration

Air scrubbers with HEPA filters capture airborne spores while work is under way.

4. Removal

Porous materials with mold growth, such as drywall, insulation and carpet, are cut out, bagged and removed.

5. Cleaning

Remaining surfaces are HEPA-vacuumed and cleaned. Hard, non-porous materials can usually be cleaned rather than replaced.

6. Drying and moisture repair

The structure is dried and the moisture source is fixed. Without this step, mold will return.

7. Clearance

A visual inspection, and where appropriate post-remediation testing, confirms the area is clean before rebuild.

Sources: US EPA mold guidance. Read our editorial policy.

Questions

Should the same company test and remediate?

Many homeowners and some states prefer an independent assessor for testing, so the company doing the work is not grading its own results.

Sources

Find mold remediation pros by state

Get it handled properly, the first time.

Compare verified mold remediation pros near you in under a minute.

Find a contractor I'm a contractor