Mold Remediation & Co.
Prevention · 5 min read

Mold on window sills: why it grows and how to stop it

Last reviewed · Based on EPA and CDC guidance · Editorial policy

Quick answer

Mold on window sills is almost always caused by condensation: warm, humid indoor air meets cold glass and water collects on the sill. Clean small spots with detergent and water and dry them. Then stop the condensation by lowering indoor humidity, improving ventilation and warming cold surfaces, as the EPA recommends.

Condensation droplets on the inside of a glass sliding window
Photo: Danielle Dolson on Unsplash

Why window sills grow mold

The EPA lists windowsills among the places where mildew commonly grows, and it treats condensation on windows, walls or pipes as a sign of high indoor humidity. Water runs down the glass and pools on the sill and in the frame tracks, where dust gives mold something to feed on. Bedrooms are often worst, because people breathe out moisture all night with the door closed.

How to clean it

  • Wear gloves and eye protection, and open the window if weather allows.
  • Vacuum loose debris from the tracks.
  • Scrub the sill, frame and tracks with detergent and water, the EPA's standard method for hard surfaces.
  • Dry everything completely, including the corners of the tracks.
  • If the sill is painted and the paint is peeling or the wood is soft, the mold may be in the wood. Don't paint over it. The EPA says to clean and dry moldy surfaces before painting. See can you paint over mold?

How to stop condensation

The EPA gives four ways to prevent condensation:

  • Reduce humidity. Keep it below 60%, ideally 30 to 50%. See the best humidity level to prevent mold.
  • Increase ventilation and air movement. Open doors between rooms, use fans, and open windows when practical.
  • Cover cold surfaces with insulation. Better-insulated windows and frames stay warmer, so less water condenses on them.
  • Raise the air temperature. Rooms kept very cold in winter get more condensation.

Small habits that help

  • Wipe condensation off windows and sills each morning in cold weather.
  • Open curtains and blinds during the day so air reaches the glass.
  • Run bathroom and kitchen exhaust fans, and make sure the dryer vents outdoors.
  • Keep furniture a few inches away from exterior walls.

When it's more than condensation

If water appears on the sill during rain, or the wall below the window is stained or soft, water may be leaking around the window from outside. That can lead to mold behind walls, and it needs a window or flashing repair, not just cleaning.

Written by the Mold Remediation & Co. editorial team from the primary sources listed below. This article is general information, not medical or legal advice. Read our editorial policy.

Questions

Is black mold on window sills dangerous?

The color doesn't tell you the risk. The CDC advises removing mold whatever its type. Small spots on a sill can usually be cleaned with detergent and water.

Why do my windows sweat every morning?

Indoor air is humid and the glass is cold. Lower humidity, improve air movement and keep rooms warmer to reduce it.

Will replacing windows stop the mold?

Better-insulated windows stay warmer, which reduces condensation. But if indoor humidity stays high, water can still condense on other cold surfaces.

Sources

Find mold remediation pros by state

Get it handled properly, the first time.

Compare verified mold remediation pros near you in under a minute.

Find a contractor I'm a contractor